Trouble-Shooting Answer To Question; Troubleshooting - Haier HWM55-918P User Manual

Trouble-shooting · Answer to question
(If there's breakdown, please pull off the power plug before checking)
The following phenomenon are not breakdowns sometimes. Please confirm again before sending it to
repair.
If there are real breakdowns, please come to the special maintenance department or after-sale
service department of our company. Do not repair it by yourself.
Phenomena
The digitron displays E0.
The drainage cannot
work, or is too slow. The
digitron displays E1.
It stops running in
midway. The digitron
displays E2.
The safety switch acts,
and the spinning cannot
work. The digitron
displays E3.
The water filling does
not work, or is slow, the
digitron displays E4.
The digitron displays E6.
The digitron displays F2.
The
machine
Not wash
does not
act
Not spin
There is abnormal sound
inside the machine
The water tap leaks
The reason
The top lid is open during
reserve procedure.
Is the drain hose blocked?
The top lid is not closed.
When using the child lock function,
if the top cover is opened, the
machine will stop and display E2
alarm. After 15 seconds the machine
will automatic drainage
Are the laundries put slantingly?
Is the machine slanting?
Is the water tap opened, or is
there water supply failure?
Is the water inlet valve blocked?
Is the water pressure too low?
The water level sensor is bad.
Overflow alarm
Is there power failure?
Is the power plug inserted tightly?
Is the water level reached preset
position?
Is the power plug inserted tightly?
Is the top lid closed reliably?
Are the laundries set flat?
Is the machine slanting?
Are the laundries put slantingly in
spinning?
Are there any foreign materials?
Is the screw of the jointer of water
inlet hose loose or awry?
How to settle
Close the top lid.

Clean the foreign material. Open and

close the top lid once.
Close the top lid.

Clear the E2 alarm, please close the top

cover and press the "START/PAUSE"
button. Then E2 alarm will be cleared.
Reorder the laundries. Close the top lid.

Place the machine horizontally, open

and close the top lid once.
Open the water tap. Open and close the

top lid once.
Clean the water inlet valve then open

and close the top lid once.
Use after the water pressure is normal.

Please contact the after-sales service

department.
Please contact the after-sales service
department.
Please use it when there's power

supply.
Insert the power plug tightly.

Fill water to the preset position.

Insert the power plug tightly.

Close the top lid.

Set the laundries flat.

Adjust the machine to be even

Reorder the laundries and close the top

lid.
Remove the foreign materials.

Fasten the screw of the jointer properly.
