Kyocera FS-C5100DN User Manual page 21

SNMPv3 Options
Selecting SNMP Settings
1
2
3
KX DRIVER
This option ensures successful Auto Configure communication using Read
community name and Write community name.
SNMPv3
This option ensures secure Auto Configure communication using a user
name and password. Authentication and privacy options are available by
selecting Settings.
Apply to other models
Select from the list of installed printing systems to apply the selected SNMP
settings.
You can select SNMPv3 options for secure communication with the printing
system.
Authentication
This option provides an algorithm to check that a transferred file has arrived
intact. Message Digest 5 (MD5) and Secure Hash Algorithm 1 (SHA1) are
hash algorithms used to authenticate packet data.
MD5
This option provides a cryptographic hash function with a 128–bit hash
value. It adds security and protection against Gateway Load Balancing
Protocol (GLBP)-spoofing software.
SHA1
This option produces a message digest that is 160 bits long. SHA1 is the
successor to MD5.
Privacy
This option uses encryption for secure communication. It is available after
you select the Authentication option. You may select one privacy option.
(IB-23 does not support AES encrypted communication.)
DES
This option uses the Data Encryption Standard for encryption. DES turns
cleartext into ciphertext via an encryption algorithm. It encrypts and decrypts
data using 8-byte blocks and a 56-bit key.
AES
This option uses the Advanced Encryption Standard for encryption. AES is a
symmetric block cipher that can process data blocks of 128 bits, using cipher
keys with lengths of 128, 192, and 256 bits. It is more secure than DES.
SNMP settings in the driver must be set to match the settings in the printing
system's Command Center.
In Device Settings > Administrator, click SNMP Settings.
Select SNMPv1/v2c or SNMPv3.
For SNMPv1/v2c, type the Read community name and Write community
name, up to 32 characters, and click OK.
For SNMPv3, type a User name up to 32 characters, and a Password from
8 to 32 characters.
To set authentication and privacy options for SNMPv3, click Settings.
Device Settings
2-7