Clear Cmos Jumper; Trusted Platform Module Header - Gigabyte GA-A75-UD4H User Manual

15) TPM (Trusted Platform Module Header)
You may connect a TPM (Trusted Platform Module) to this header.
16) CLR_CMOS (Clearing CMOS Jumper)
Use this jumper to clear the CMOS values (e.g. date information and BIOS configurations) and reset
the CMOS values to factory defaults. To clear the CMOS values, place a jumper cap on the two pins to
temporarily short the two pins or use a metal object like a screwdriver to touch the two pins for a few
seconds.
Always turn off your computer and unplug the power cord from the power outlet before clearing the CMOS
•
values.
After clearing the CMOS values and before turning on your computer, be sure to remove the jumper cap
•
from the jumper. Failure to do so may cause damage to the motherboard.
After system restart, go to BIOS Setup to load factory defaults (select Load Optimized Defaults) or manually
•
configure the BIOS settings (refer to Chapter 2, "BIOS Setup," for BIOS configurations).
TPM
w/housing
20
2
Pin No. Definition
1 LCLK
2 GND
3 LFRAME
4 No Pin
5 LRESET
6 NC
7 LAD3
8 LAD2
9 VCC3
10 LAD1
Open: Normal
Short: Clear CMOS Values
- 31 -
Voltage measurement module(X58A-OC)
PCIe power connector (SATA)(X58A-OC)
19
1
Pin No. Definition
11 LAD0
12 GND
13 NC
14 ID
15 SB3V
16 SERIRQ
17 GND
18 NC
19 NC
20 SUSCLK
Hardware Installation
1
PWM Switch (X58A-O
3 2 1
DIP
DIP
1 2 3