Lenovo 20074CU User Manual page 45

log on to the Windows domain server. To enable this setting, go to Option,
and select the check box for Use Windows logon user name and
password to authenticate the wireless network.
When tunnel authentication is set to GTC, you can configure the following settings.
Use one-time token
Under GTC tunnel authentication, the connection is established after a
temporary password for tunnel authentication, called a token, specified by
RSA security is entered. To apply this setting, select this check box. Then,
whenever you deploy the location profile, a message asking you to input
the token number and ID is displayed.
Use temporary user ID and password
If you select this setting, a message will be displayed when you deploy this
location profile, asking you to enter the user ID and password for tunnel
authentication. After you enter the necessary information, the authentication
will start. This option is used to connect to the wireless network manually.
Use saved user ID and password
The user ID and password for the tunnel authentication are set in advance.
If the use of the Windows logon user name and password for wireless
network authentication is enabled, the available user ID and password will
be used for tunnel authentication at Windows logon, and the computer will
log on to the Windows domain server. To enable this setting, go to Option,
and select the check box for Use Windows logon user name and
password to authenticate the wireless network.
Chapter 2. Using location profiles
35