Table of Contents
Advertisement
5. ATTACHING AN ARM STAND
The L461 can be used with an arm stand by removing the tilt stand and attaching the
arm stand to the terminal.
´ Use an arm stand that satisfies the followings.
• When using the L461 with an arm stand,
the arm stand must be VESA approved :
* Use an arm stand with a 75 mm x 75 mm hole
spacing on the arm mounting pad.
* Use an arm stand that is able to support an object
weighting 8.0 kg.
´ TÜV/GS approved arm stand.
´ Use an arm stand with sufficient stability
(mechanical firmness) to support the weight of the
monitor.
´ Use an arm stand remaining that position where it
is manually moved.
´ Use an arm stand with the ability to tilt the monitor
forward and backward.
´ Please connect cables after attaching an arm stand.
Setup Procedure
1.
Lay the L461 down as shown below. Do not scratch the panel.
2.
Remove the tilt stand by loosening the screws (2 pcs of M4 x 10 mm).
M4 x 16 mm
75 mm
Soft Cloth or
Cushion
5. ATTACHING AN ARM STAND
75 mm
27
Advertisement
Table of Contents
