Advertisement
Make sure the chimes are assembled or disassembled by at least two persons.
1
A
2
B
3
C
C
4
5
B
B
C
6
6
A
B
C
1
Connect the pedal assembly to the left and
right base sections.
Position the pedal assembly and left/right base
sections as shown in the illustration below.
* The following procedure is carried out to en-
sure that the performer faces forward when
playing the instrument.
Fully loosen screws A, and then slide the pedal
assembly pipe all the way into the hole on the
base section. Tighten screws A to secure.
After connecting the assembly pipe to the base
sections, lock the casters (left and right).
2
Insert the side columns into the holes on
the left and right base sections.
Fully loosen screws B and insert the end of the
side column pipe with the small hole on its side,
all the way into the left and right side base sec-
tions.
* Both left and right side columns are the same.
* To make attachment of the damper and hanger
sections easier, do not tighten screws B yet.
3
Set the damper.
Fully loosen screws C and slide the damper onto
the side columns from above so that the damper
rod is positioned on the right. Slide the damper
down the columns until it comes to rest on the
damper rests.
* To make attachment of the hanger section
easier, do not tighten screws C yet.
4
Set the hanger.
Slide the hanger onto the side columns from
above. Slide it all the way onto the columns.
5
Tighten screws B and C.
Firmly tighten screws B and C on both right and
left sides and secure.
6
Set the damper pedal.
Pull the damper pedal out to the front, and then
hook the hook on the end of the pull rod onto the
damper rod. At this time, pull down on the pull
rod knob to hook onto the damper rod, then re-
lease the pull rod knob.
* Do not press down on the damper pedal. Do-
ing so engages the damper and the sound
columns cannot be hung.
Advertisement
