Table of Contents
Advertisement
2.5
Power menu
The Power menu items allow you to change the settings for the Advanced Configuration and
Power Interface (ACPI) and the Advanced Power Management (APM). Select an item then
press <Enter> to display the configuration options.
2.5.1
Suspend Mode [Auto]
Allows you to select the Advanced Configuration and Power Interface (ACPI) state to be used
for system suspend. Configuration options: [S1 (POS) Only] [S3 Only] [Auto]
2.5.2
ACPI 2.0 Support [Enabled]
Allows you to enable or disable the Advanced Configuration and Power Interface (ACPI) 2.0
support. Configuration options: [Disabled] [Enabled]
2.5.3
ACPI APIC Support [Enabled]
Allows you to enable or disable the Advanced Configuration and Power Interface (ACPI)
support in the Advanced Programmable Interrupt Controller (APIC). When set to Enabled, the
ACPI APIC table pointer is included in the RSDT pointer list. Configuration options: [Disabled]
[Enabled]
2.5.4
APM Configuration
Restore on AC Power Loss [Always Off]
When this item is set to [Always Off], the system goes into off state after an AC power
loss. When this item is set to [Always On], the system goes on after an AC power loss.
Configuration options: [Always Off] [Always On] [Last State]
Power on From S5 By PME# [Disabled]
Enables or disables PME wake from sleep states. Configuration options: [Disabled] [Enabled]
Power on From S5 By Ring [Disabled]
Enables or disables ring to generate a wake event. Configuration options: [Disabled]
[Enabled]
2-16
Chapter 2: BIOS information
Advertisement
Table of Contents
