Asus M4A78LT PLUS User Manual page 29

4. AMD SB710 Serial ATA 3.0 Gb/s connectors (7-pin SATA6G_1~4)
®
These connectors are for the Serial ATA 3.0 Gb/s signal cables for Serial ATA hard disk
drives. If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID 1, or
RAID 10 configuration through the onboard AMD
M4A78LT PLUS
M4A78LT PLUS SATA connectors
• These connectors are set to IDE mode by default. In IDE mode, you can connect Serial
ATA boot/data hard disk drives to these connectors. If you intend to create a Serial ATA
RAID set using these connectors, set the type of the SATA connectors in the BIOS to
[RAID]. See section 2.3.4 SATA Configuration for details.
• You must install Windows
ATA hard disk drives. The Serial ATA RAID feature is available only if you are using
Windows
• When using hot-plug and NCQ, set the type of the SATA connectors in the BIOS to
[AHCI]. See section 2.3.4 SATA Configuration for details.
5. Speaker connector (4-pin SPEAKER)
This 4-pin connector is for the chassis-mounted system warning speaker. The speaker
allows you to hear system beeps and warnings.
M4A78LT PLUS
M4A78LT PLUS Speaker out connector
ASUS M4A78LT PLUS
SATA3G_3
SATA3G_1
XP Service Pack 3 or later version before using Serial
®
XP SP3 or later version.
®
SPEAKER
PIN 1
SB710 controller.
®
SATA3G_4
SATA3G_2
1-19