Front Panel - NETGEAR WNR2200 - N300 Wireless Router Setup Manual

Front Panel

Figure 2
The front panel has seven status lights that you can use to monitor and verify various conditions.
There are also two switch buttons on the right (or at the top if the router is in its stand). The status
lights are described in
Table 1. Status Light Descriptions
Item Function Activity
1. Power/Test Solid Amber
Solid Green
Off
2. Internet Off
Solid Amber
Solid Green
LAN Solid Green
3.
(Ports 1–4)
Solid Amber
Off
USB Off
4.
Solid Green
Getting to Know Your Wireless Router
3
1
2
Table 1, and the switch buttons in
Description
The unit is starting up after being powered on.
The unit startup has completed; the unit is ready.
Power is not supplied to the router.
No Ethernet cable is connected to the modem.
The Ethernet cable connection to the modem has been detected.
An IP address has been received; ready to transmit data.
The LAN port has detected a 100 Mbps link with an attached device.
The LAN port has detected a 10 Mbps link with an attached device.
No link is detected on this port.
No USB device is connected, or the "Safely Remove Hardware"
button has been pressed and it is now safe to remove the attached
USB device.
The USB device has been accepted by the Router and is ready to be
used.
4
5
6
Table 2.
3