Testing The Path From A Pc To The Internet - NETGEAR WNR2200 - N300 Wireless Router Setup Manual

– Verify that the Ethernet card driver software and TCP/IP software are both installed
and configured on your computer.
– Verify that the IP address for your router and your computer are correct and that the
addresses on both begin with 255.255.255.0.

Testing the Path from a PC to the Internet

After verifying that the path between your computer and the N300 wireless router works correctly,
test the path from your PC to the Internet. From the Windows Start > Run... menu, type:
PING -n 10 <IP address>
where <IP address> is the IP address of a remote device such as your ISP's DNS server.
If the path is functioning correctly, replies as in the previous section are displayed. If you do not
receive replies:
• Check that your PC has the IP address of your router listed as the default gateway. If the IP
configuration of your PC is assigned by DHCP, this information is not visible in your PC's
Network Control Panel. Verify that the IP address of the router is listed as the TCP/IP default
gateway.
• Check to see that the network address of your PC (the portion of the IP address specified by
the netmask) is different from the network address of the remote device.
• If your ISP assigned a host name to your PC, enter that host name as the account name in the
Basic Settings screen.
Troubleshooting 34