Table of Contents
Advertisement
Installation
Electrical connection
Any electrical work that is required
to install this washing machine
MUST be carried out by a qualified
electrician.
Warning: THIS APPLIANCE MUST
BE EARTHED
Before making any electrical connections,
ensure that:
• Ensure the power socket is suitable for the
maximum power of the washing machine (fuses
in the power circuit must be 15 amp).
• The supply voltage
should be the same as
that indicated in the
technical specifi cations
(page 18) and the
appliance rating plate
(located where shown).
• The appliance should be
earthed and in compliance
with the applicable law .
• Additional earth cables should not be
necessary if the plug and socket ar e earthed.
If necessary, an additional earth cable should be
attached to the earth terminal on the back of the
washing machine and earthed.
• When installed, the power socket must be
within easy reach.
• The use of adapters, multiple connectors or
extension cables are not recommended.
• The appliance must be connected to a 220-
240 volt 50 cycle AC supply by means of a three
pin socket, suitably earthed and pr otected by a
15 amp fuse.
• Should the fuse need to be replaced, a 15
amp fuse approved to BS1363/A must be used.
• The plug contains a removable fuse cover that
must be refitted when the fuse is r eplaced. If the
fuse cover is lost or damaged, the plug must
not be used until a replacement cover has been
fitted or the plug is replaced.
• A damaged plug should be cut of f as close to
the plug body as possible, the fuse should be
removed and the plug disposed of safely .
7
Plug r eplacement (UK & Ireland only)
Should you need to replace the plug; the wir es in
the power cable are coloured in the following way:
Blue – Neutral 'N'
Brown – Live 'L'
Green & Y ellow – Earth 'E'
As the colours of the wir es in the power cable
may not correspond with the colour ed markings
identifying the terminals in your plug, and pr oceed
as follows:
The green & yellow wire must be connected to the
terminal in the plug that is marked with the letter E
or by the earth symbol.
。
30
C
90
C
。
。
。
40
C
60
C
40
C
。
HW50-1010
The blue wire must be connected to the terminal
that is marked with the letter N.
The brown wire must be connected to the terminal
that is marked with the letter L.
If the power lead is damaged, it must be r eplaced
Rating plate
by a qualified electrician.
Connect
blue lead
to 'N' -
Neutral
Connect green/yellow
lead to 'E' or - Earth
Connect
brown lead
E
to 'L' - Live
L
N
Hide quick links:
Advertisement
Table of Contents
