Appendix; About Folder And File Names; Troubleshooting - HP s510 User Manual

Appendix

About Folder and File Names

Your camera automatically creates specific directory of folder in the internal memory cards to organize
captured photos, videos and audio files.
File Naming
File names begin with "DSCI" and followed by a 4-digit number that increases in sequence. File numbering
starts from 0001 when a new folder is created.
If the highest folder number is 999 and the highest file number exceeds 9999, the camera will display the
warning message "Folder cannot be created". When this happens, try one of the following ways:
• Reset the file number. See "Setting File Numbering" on page 58.
Do not change the folder and file names in the memory card using your PC. It may be unable
to playback the data using the camera.

Troubleshooting

Problem
Camera does not turn on.
Camera turns off
automatically.
Power will not turn off.
Nothing happens when a
button is pressed.
LCD turns dark.
Empty battery icon is
displayed on the LCD, then
the camera turns off.
LCD monitor displays
"No image".
LCD monitor displays
"Not available for this file".
LCD monitor displays
"Memory full".
LCD monitor displays
"File locked"
LCD monitor displays
"Card locked".
LCD monitor displays
"Format error".
LCD monitor displays
"Card error".
No photo displays on the
TV screen.
The lens is stuck and will
not retract or extend.

The battery may not be loaded correctly.

The battery may be exhausted. Charge or replace the battery.

Power Saving may have activated. Turn power back on.

The battery may be dead. Charge the battery.
Remove the battery from the camera and then reload it.
Press any button except the Power button to turn on the LCD.
Battery is exhausted, please replace or recharge.
There is no photo file in the memory card. Photo file format may not be
supported.
Function is only available for specific file types. File format is not
supported.
Memory card is full. Replace the memory card with a new one or delete
unnecessary photo/video/audio clips.
This file is locked. Unlock the file. See "Protect" on page 48.
The memory card is protected. Remove the card and slide the
write-protect switch to its unlock position.
The card may be damaged. You can either change the card or wipe to
clean the connected points.
The memory card is protected. Remove the card and slide the
write-protect switch to its unlock position.
Incorrect TV-out type was selected. Set the correct TV-out type to match
your TV system.
Do not force the lens to go back.
The type of the battery used may be incorrect or the battery power level
is too low. Change the battery or charge the battery before using the
.
camera.
Cause and/or Action
63