Paradyne 3610 Installation Instructions page 2

P a r a dyn e
3600 Hubbing Device Installation Instructions
Document Number 3610-A2-GZ45-10
March 1996
Overview
This document describes the pin assignments and
procedure for installing the 3600 Hubbing Device.
The 3600 Hubbing Device is required to daisy
chain a Model 3610 Data Service Unit (DSU) onto
a Network Management System (NMS) control
channel (CC) or diagnostic channel (DC).
The hubbing device plugs into a modular jack
located on the rear of the DSU and provides two
8-pin modular jacks for DC/CC connections.
Prior to installing a 3600 Hubbing Device, check the
hubbing device for damage. If there are signs of damage,
report this immediately to your shipping representative
and your AT&T Paradyne representative.
3610-A2-GZ45-10
This equipment has been tested and
found to comply with the limits for a
Class A digital device, pursuant to
Part 15 of the FCC rules. These limits are
designed to provide reasonable
protection against harmful interference
when the equipment is operated in a
commercial environment. This
equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with
the instruction manual, may cause
harmful interference to radio
communications. Operation of this
equipment in a residential area is likely
to cause harmful interference, in which
case, the user will be required to correct
the interference at his own expense.
The authority to operate this equipment
is conditioned by the requirement that no
modifications will be made to the
equipment unless the changes or
modifications are expressly approved by
AT&T Paradyne.
TO USERS OF DIGITAL APPARATUS IN
CANADA: The digital apparatus does not
exceed the Class A limits for radio noise
emissions from digital apparatus set out
in the radio interference regulations of
the Canadian Department of
Communications.
March 1996
WARNING
1