Paradyne 3610 Software Installation Manual page 2

P a r a dyn e
3600 Series DSU Firmware Installation Instructions
Document Number 3610-A2-GZ43-20
February 1996
Firmware Version
Requirements
This document describes the procedure for installing
replacement firmware in a Model 3610 or 3611 Data
Service Unit (DSU). Follow the appropriate set of
instructions for either the Model 3610 or Model 3611
DSU.
Identity (ID) displays a report listing the DSU's model
number, serial number, software/firmware version,
network address, DDS rate and installed options.
.
To see your firmware version:
Procedure
1. Access the Status (Stat) branch from the front
panel.
2. Select ID. Press the
DSU SW ver appears.
Prior to starting the installation, make a copy of the
Configuration Worksheets provided in the User's Guide,
DBM Options Supplement, and/or TDM, MCMP, Digital
Bridge Options Supplement.
Access the Configuration (Confg) branch and record
all the current configuration option sets on the worksheets.
3610-A2-GZ43-20
key until the
February 1996
Model 3610 Firmware
Installation
HANDLING PRECAUTIONS
FOR
STATIC-SENSITIVE DEVICES
AT&T Paradyne products are
designed to protect sensitive
components from damage due to
electrostatic discharge (ESD)
during normal operation. When
performing installation procedures,
however, take proper static control
precautions to prevent damage to
equipment. If you are not sure of
the proper static control
precautions, contact the nearest
AT&T Paradyne Customer
Support office.
1