Setting Up The Data; Setting The Defaults - Raytheon RayChart 620 Operation Manual

58

6.2 Setting Up the Data

The RayChart 620 allows you to set up a number of parameters that
control the way it operates. These are accessed from the SET UP
menu.
The SET UP menu options control the following:
• System set up
• Navigation set up
• Chart Plotter set up
• Alarms and timers set up
• Position fixer initial settings and reset
• Memory C-Card transfers
Before you make any changes:
1. Check the lists of parameters and options provided in the tables in
2. Decide what changes, if any, you wish to make.
3. Fill in the required settings in the spaces provided in the tables.
Once you have done this, follow the instructions given below to make
the changes.

Setting the Defaults

To set the setup defaults:
1. Press the MENU key to display the SET UP menu above the right
2. Use the trackpad or SET UP soft key to highlight the required menu
3. Use the up and down trackpad controls to move the selection bar
4. When the required parameter or menu is highlighted, press
this section.
hand soft key. The option you used last is currently highlighted.
option, and press ENTER.
The requested set up menu is displayed, listing the parameters and
their current settings and, for some items, menus of further
parameters. For example, the SYSTEM set up menu is shown on
the following page.
up and down the list.
ENTER.
For menus, a further menu of parameters is displayed. Repeat
steps 3 and 4 to select a parameter.
RayChart 620