Advancing To The Next Leg Of The Route; Erasing A Route - Raytheon RayChart 620 Operation Manual

30
To stop following the current route, select the OFF option from the
ROUTE menu. This option replaces the FOLLOW option when the
route is already active.

Advancing to the Next Leg of the Route

When you reach the active waypoint, the RayChart will automatically
start tracking towards the next waypoint in the route.
If you have set the Arrival Alarm when you set up your system, the
alarm buzzer sounds and a message is displayed when you reach the
waypoint.
The alarm is cleared after 7 seconds. You can clear the alarm earlier by
pressing any key.
Note: If you are tracking to a single waypoint or to the last waypoint of
the route, you must arrive at the waypoint circle to trigger the alarm. For
intermediate waypoints in the route, the alarm is also triggered if you are
off-course and reach a line perpendicular to the track through the target
waypoint.
You can also advance to the next leg even if you have not reached the
current waypoint. From the ROUTE menu, highlight the NEXT LEG
option and press ENTER. The RayChart will start tracking from the
vessel's current position towards the next waypoint.

Erasing a Route

The RayChart can store up to 20 routes. If you have used all the route
slots and want to create a new route, you can erase a selected route.
Note: If required, you can store routes on a Memory C-Card for future
use, as described in Chapter 6, before deleting them from the
RayChart's memory.
The RayChart will start tracking towards the waypoint, unless a
waypoint is already active.
If you are already tracking to a waypoint (either by following a route
or using the GO TO option), a warning message is displayed (see
page 23).
D3832-1
RayChart 620