Making A New On-Screen Route - Raytheon RayChart 620 Operation Manual

24
The menu options are as follows:
MAKE / EDIT Used to set up a new route using the cursor. You can
ERASE
FOLLOW
or OFF
REVERSE
NEXT LEG

Making a New On-Screen Route

Making a new route using the ROUTE soft key couldn't be easier:
1. Move the cursor to the area in which you wish to make the route,
2. Press the ROUTE soft key to display the Route menu and the
3. If required, press the SELECT soft key to select an empty route slot.
4. Press ENTER to select the highlighted Make/Edit option.
5. Use the trackpad to move the cursor to the position on the chart
6. Press the PLACE WPT soft key.
also use this option edit an existing route, adding and
removing waypoints, and to edit route information such
as waypoint names and symbols.
Used to clear the existing route from memory. This
deletes the route, but not its component waypoints.
Used to start tracking to the first waypoint on the route.
Used to stop tracking. This soft key is displayed instead
of FOLLOW when a route is already active.
Used to reverse the tracking order of the waypoints in
the route.
Used to proceed to the next leg of the route.
and select a suitable chart scale.
current route.
Note: If the full list of ROUTE options is displayed, a route already
exists in the selected route slot. You can select ERASE to delete the
route (see page 30), or continue with this procedure to add
waypoints to the existing route, as described below.
The soft key labels change, as shown in the illustration below.
where you want your first waypoint to be.
Note: You can position the cursor on an existing waypoint, if
required. This waypoint will be included in the route, and a new
waypoint will not be created.
The waypoint appears on the screen at the current cursor position,
together with the waypoint number assigned by the RayChart.
RayChart 620