Panasonic DMC LZ1 - Lumix Digital Camera Operating Instructions Manual page 44

■ Available fl ash settings by recording mode
The available fl ash settings depend on the
recording mode.
( : Available, — : Not available,
setting)
*
2
* When AUTO is selected, depending on
2
the type of subject or brightness, fl ash
is set i AUTO [
reduction [ ], or i Slow sync./Red-
eye reduction [
• The fl ash setting may change when you
44
VQT1L86
Advanced-Shooting
: Initial
], i AUTO/Red-eye
].
change the recording mode. Change the
fl ash setting again if necessary.
• The fl ash setting is memorized even if
the camera is turned off. However, the
fl ash setting is reset to the initial setting
when the advanced scene mode or
scene mode is changed.
The available fl ash range to take pictures
■
ISO sensitivity Available fl ash range
AUTO 50 cm (1.64 feet) to
6.8 m (22.31 feet) (Wide)
1.0 m (3.28 feet) to
3.8 m (12.47 feet) (Tele)
ISO100 50 cm (1.64 feet) to
2.1 m (6.88 feet) (Wide)
1.0 m (3.28 feet) to
1.2 m (3.94 feet) (Tele)
ISO200 50 cm (1.64 feet) to
3.0 m (9.84 feet) (Wide)
1.0 m (3.28 feet) to
1.7 m (5.58 feet) (Tele)
ISO400 60 cm (1.97 feet) to
4.3 m (14.11 feet) (Wide)
1.0 m (3.28 feet) to
2.4 m (7.88 feet) (Tele)
ISO800 80 cm (2.62 feet) to
6.0 m (19.69 feet) (Wide)
1.0 m (3.28 feet) to
3.4 m (11.16 feet) (Tele)
ISO1600 1.15 m (3.77 feet) to
8.6 m (28.22 feet) (Wide)
1.0 m (3.28 feet) to
4.8 m (15.75 feet) (Tele)
• The available focus range differs
depending on the recording mode.
• When you use the fl ash when you
have set ISO sensitivity to [AUTO], ISO
sensitivity automatically becomes a
maximum of [ISO1000].
• The edges of the picture may appear
dark if you shoot a very close subject with
the fl ash while the zoom lever is close to
the W side. Zoom in slightly if this occurs.
• Available fl ash range varies depending
on ISO sensitivity in [HIGH SENS.].
– W: approximately 1.15 m (3.77 feet) to
17.2 m (56.43 feet)
– T: approximately 1.0 m (3.28 feet) to
9.6 m (31.49 feet)