Table of Contents
Advertisement
7. The LCD monitor or
viewfinder indications blink.
8. Digital Zoom does not work.
Video and D.S.C. Playback
SYMPTOM
9. Play, Rewind and Fast-Forward
functions do not work.
10. The tape is moving, but there is
no picture.
11. Blocks of noise appear during
playback, or there is no
playback picture and the
screen becomes blue.
12. A memory card cannot be
played back.
13. The image on the 4:3 TV is
elongated vertically (squeeze).
14. The screen of the LCD monitor
or viewfinder is blackened or
blocks of noise appear on its
right side when the Power
Switch is set to "P" for
dubbing (but 4·9 is not
pressed).
7. • Certain Wipe/Fader effects,
certain modes of Program
AE, "OIS" and other
functions that cannot be used
together are selected at the
same time.
8. • 10X optical zoom is selected.
• The Recording Mode Switch
is set to "MEMORY".
POSSIBLE CAUSES
9. • The Power Switch is set to
"A" or "M".
• The Playback Mode Switch is
set to "MEMORY".
10. • Your TV has AV input
terminals, but is not set to its
VIDEO mode.
• The cassette holder cover is
open.
11.
—
12. • The Power Switch is set to
"A" or "M".
• The Playback Mode Switch is
set to "VIDEO".
13. • This occurs during recording
in HD or SD mode when a
tape (its erase protection tab
is set to "REC") is loaded.
• The component video cable
and S/AV/Editing cable are
connected simultaneously.
14. • The S/AV/Editing cable is
connected and "S/AV
INPUT" (
pg. 41) is set to
"A/V IN" or "S IN".
7. • Re-read the sections covering
Wipe/Fader effects, Program
AE and "OIS". (
8. • Set "ZOOM" to "40X" or
"200X". (
pg. 36)
• Set the Recording Mode
Switch to an appropriate
position except "MEMORY".
CORRECTIVE ACTION
9. • Set the Power Switch to
"P". (
pg. 24)
• Set the Playback Mode
Switch to "VIDEO".
10. • Set the TV to the mode or
channel appropriate for
video playback. (
• Close the cassette holder
cover. (
pg. 18)
11. • Clean the video heads with
an optional cleaning
cassette.
12. • Set the Power Switch to
"P". (
pg. 29)
• Set the Playback Mode
Switch to "MEMORY".
13. • This is not a malfunction.
• Disconnect either of two
cables.
14. • This is not a malfunction.
After dubbing, set "S/AV
INPUT" back to "OFF".
71
EN
pg. 37, 50)
pg. 26)
Advertisement
Table of Contents
