Clearing Blockages; Emptying The Clear Bin Tm; Cleaning The Clear Bin Tm - Dyson DC22 Operating Manual

USINg YOUR dYSON vACUUM
CAUTION:
• Do not allow the vacuum to be used by anyone who may not be able to operate it
safely.
• Do not use your vacuum outdoors or on wet surfaces, or to vacuum water or other
liquids – electric shock or personal injury could occur.
• If the cord is damaged, turn power off and disconnect from the socket outlet
immediately. The cord must only be replaced by Dyson or our appointed service
agents to avoid a hazard.
• Take extra care when vacuuming on stairs; always work with the vacuum at the bottom
of the stairs. Keep the vacuum on the floor. Do not put the vacuum on chairs, tables
etc.
• Switch off and unplug the vacuum before changing accessories, removing the
clear bin , filters, hose, checking for blockages or before performing any other
TM
maintenance operation.
• The use of an extension cord is not recommended.
• Do not lubricate any parts, or carry out any maintenance or repair work other than
that shown in this Operating Manual, or as advised by the Dyson Helpline.
• If the vacuum is not functioning properly, has been dropped, damaged, left outdoors,
or immersed in liquid, contact the Dyson Helpline.
• Check to ensure your electricity supply corresponds to that shown on the rating plate
which can be found behind the clear bin
• Do not press the cyclone release button while carrying the vacuum or it could fall and
cause injury.
PLEASE NOTE:
• The brush bar will reset to 'ON' each time you start the vacuum.
• Consult your flooring manufacturer's recommended instructions before vacuuming
and caring for your flooring, rugs and carpets. Some carpets will fuzz if a rotating
brush bar is used when vacuuming. If this happens, we recommend vacuuming in bare
floors mode and consulting with your flooring manufacturer.
• This vacuum is designed for household indoor and car use only; it should not be used
or stored outdoors. It should not be used for commercial or rental purposes.
• The vacuum may be used inside a garage only with the Model 08909 Dyson Car
Cleaning Kit accessories. If used in a garage, care should be taken to wipe the
soleplate and wheels with a dry cloth after vacuuming to clean off any sand, dirt or
pebbles which could damage delicate floors.
• Fine dust such as plaster dust or flour should only be vacuumed in very small amounts.
• Do not use the vacuum to pick up sharp hard objects, small toys, pins, paper clips etc.,
because they may damage the vacuum.
• When vacuuming, certain carpets may generate small static charges in the clear bin
or wand. These are not associated with the electricity supply. To minimize any effect
from this, do not put your hand or insert any object into the clear bin
first emptied it and rinsed it out with cold water.
• This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
• If you need to reprogram the radio frequency on the wand please contact the
Dyson Helpline.
EMPTYINg ThE ClEAR bIN
CAUTION:
• Turn power off and unplug before emptying the clear bin
unattended. The motor will operate with the clear bin
PLEASE NOTE:
• Empty the clear bin as soon as the MAX mark level is reached.
TM
• Do not use the vacuum without the clear bin
electric shock or personal injury.
• Emptying inside a bag is recommended for allergy sufferers.
ClEANINg ThE ClEAR bIN
CAUTION:
• Do not immerse the whole cyclone in water.
• Ensure clear bin is completely dry before re-fitting.
TM
PLEASE NOTE:
• Do not use detergents, polishes or air fresheners to clean the clear bin
• Clean the shroud with a cloth or dry brush to remove lint and dust.
• Do not put the clear bin in a dishwasher.
TM
WAShINg YOUR FIlTERS
CAUTION:
• Switch 'OFF' and unplug the vacuum before removing the filters.
• Ensure filters are completely dry before refitting to the vacuum.
PLEASE NOTE:
• This vacuum has two filters, located as shown. It is important to check your filters
regularly and wash at least every three months according to instructions, to maintain
performance.
• Filter B should be rinsed and tapped out until the water runs clean, then tapped out
again to ensure all excess water is removed. This will normally require up to 10 rinse
cycles. Please leave to dry completely for 24 hours.
• The filters may require more frequent washing if vacuuming fine dust.
• Do not use detergents to clean the filters.
• Do not put the filters in a dishwasher, washing machine, tumble dryer, oven,
microwave or near an open flame.
8
. The vacuum must only be used as rated.
TM
TM
unless you have
TM
TM
and do not leave
TM
off.
TM
in place. Failure to do so could result in
TM
TM
.
TM

ClEARINg blOCKAgES

CAUTION:
• Turn power off and unplug before checking for blockages. Failure to do so could result
in electric shock or personal injury.
• Clear blockage before re-starting.
• Beware of sharp objects when clearing blockages.
• Refit all parts of the vacuum securely before using it.
PLEASE NOTE:
• Clearing blockages is not covered by your vacuum's limited warranty.
• This vacuum is fitted with an automatically resetting thermal cut-out. If the vacuum
overheats it will cut-out and it must then be switched off and unplugged immediately
and allowed to cool down before attempting to check filters or for blockages.
• Large items may block the tools or wand inlet, if this happens switch the vacuum off
and remove the plug before removing the blockage. Do not operate the wand release
catch.
1
2
3