Table of Contents
Advertisement
Battery Installation
The Telephone Access Module requires a 9-volt alkaline
battery (not included) to provide the power to dial an
alert indicating an extended power interruption. (See
Power Outage Setting discussion in Configuring Your
Telephone Access Module section.)
CAUTION
Dead or Missing Battery Hazard.
Can prevent Telephone Access Module from
dialing power outage alert.
Check battery annually or before leaving for
extended absence.
To install or replace the battery:
1.
Remove the front cover latch pin (Fig. 2).
2.
Grasp the top of the front cover and swing it down
(Fig. 3).
3.
Connect the battery leads to the battery (Fig. 4).
4.
Insert the battery in the slot.
5.
Close the cover.
6.
Re-insert the front cover latch pin.
Fig. 2. Removing front cover latch pin.
5
M14813
69-1353
Advertisement
Table of Contents
