Table of Contents
Advertisement
Single device
Two devices
•
Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
•
Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.
If any device jumper is set as "Cable-Select," make sure all other device
jumpers have the same setting.
3.
Serial ATA connectors (7-pin SATA1, SATA2, SATA3, SATA4, SATA5,
SATA6)
Supported by the NVIDIA
connectors are for the Serial ATA signal cables for Serial ATA hard disk drives
that allows up to 3Gb/s of data transfer rate.
If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID 1,
RAID 10, RAID 5, or JBOD configuration. Refer to Chapter 5 for details on
how to set up the RAID configurations.
These connectors are set to SATA by default. In SATA mode, you can connect
Serial ATA boot or data hard disk drives to these connectors. If you intent to
create a Serial ATA RAID set using these connectors, enable the RAID function
of each port from the nVIDIA RAID Setup sub-menu item in the BIOS. See
section "4.4.7 Onboard Device Configuration" for details.
M2N-LR/SATA
®
M2N-LR/SATA SATA Connectors
ASUS M2N-LR Series
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
nForce™ 570 SLI MCP (MCP55P) chipset, these
®
SATA1
SATA2
Mode of
Cable connector
device(s)
-
Black
Black
Master
Slave
Gray
Master
Black or gray
Slave
SATA3
SATA4
SATA5
SATA6
2-2
Advertisement
Table of Contents
