Table of Contents
Advertisement
The Create New Array screen shows the disks you can add to make up the
3.
IME volume.
Integrated Mirroring Enhanced (IME) supports three to ten disks, or seven
mirrored disks plus two hot spare disks. Use the arrow key to select a disk,
then move the cursor to the RAID Disk column. To include this disk in the
array, press <+>, <->, or <Space>.
You may also specify the Hot Spare disk here. Select the disk, then move the
cursor to the Hot Spr column, then press <+>, <->, or <Space>.
LSI Logic Config Utility
Create New Array -- SAS1064E
Array Type:
Array Size(MB):
Slot
Num
0
1
2
3
Esc = Exit Menu
SPACE/+/- = Select disk for array or hot spare
By default, the RAID Disk field shows No before array creation. This field is
grayed out under the following conditions:
•
•
•
•
4.
Repeat step 5 to add the other disks to the volume.
5.
When done, press <C> to create the array, then select Save changes then
exit this menu.
6.
The utility creates the array.
LSI Logic Config Utility
Processing...may take up 1 minute
Creating RAID array
5-14
Device Identifier
SEAGATE ST373454SS
SEAGATE ST373454SS
SEAGATE ST373454SS
SEAGATE ST373454SS
F1/Shift+1 = Help
The disk does not meet the minimum requirements for use in a RAID array.
The disk is not large enough to mirror existing data on the primary drive.
The disk has been selected as the Hot Spare for the RAID array.
The disk is already part of another array.
Create and save new array?
Cancel Exit
Save changes then exit this menu
Discard changes then exit this menu
Exit the Configuration Utility and Reboot
v6.16.00.00 (2007.05.07)
IME
51498
RAID
Hot
Drive
Disk
Spr
Status
0003
[Yes]
[NO]
------- ----
0003
[NO]
[NO]
------- ----
0003
[Yes]
[NO]
------- ----
0003
[Yes] [NO]
------- ----
C = Create array
v6.16.00.00 (2007.05.07)
Pred
Size
Fail
(MB)
70007
70007
35003
35003
Chapter 5: RAID configuration
Advertisement
Table of Contents
