HTC Verizon Wireless XV6800 Quick Start Manual page 9

Powering your wireless device on for the first time
It's important to fully charge the battery before turning on your wireless
device.
To turn on the power, press and hold the POWER button. When you turn on
your wireless device for the first time, a Quick Start Wizard will guide you to
calibrate the touch screen display and to set the regional settings, date and
time, and device password.
Charging the battery
Some batteries perform best after several full charge/discharge cycles. You
can charge the battery in one of the following ways:
• Connect your wireless device directly to an electrical outlet using the
AC adapter.
• Plug the Mini USB cable to the USB port on your PC and to the sync
connector on your wireless device.
Charging is indicated by a solid amber light on the LED indicator. After the
battery has been fully charged, the LED indicator becomes green.
Powering your wireless device off
Pressing the POWER button shortly turns off the display temporarily and
switches your wireless device to Sleep mode. This suspends your wireless
device to a low power state to save battery power, but you will still be able
to receive calls and messages. To turn the display back on, simply press the
POWER button again.
To turn off the power, press and hold the POWER button. A message will
then be displayed, prompting for your confirmation to turn off the power.
Tip: Your wireless device also automatically goes into Sleep mode when the wireless device has been left
idle for a certain amount of time. Tap Start > Settings > System tab > Power > Advanced tab if
you want to change the timeout period.
pg
9