Clearing the memory
Reference sections
To clear
All memorized settings
Rebooting the receiver
If the buttons on the receiver or the remote
control do not work due to a malfunction of the
receiver, reboot the receiver.
Hold down ?/1 for 10 seconds.
When the lamp above ?/1 flashes in green, the
reboot starts.
About support information
Refer to the following web site for details of
the latest information on the receiver.
http://www.sony.com/essupport
132
US
Specifications
AUDIO POWER
SPECIFICATIONS
See
page 89
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 8 ohm loads, both channels driven, from
20 – 20,000 Hz; rated 100 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
POWER OUTPUT
Rated Power Output at Stereo Mode
Reference Power Output
1)
2)
Frequency response
SA-CD/CD, TV,
VIDEO 1/2, SAT/CATV
Inputs (Analog)
SA-CD/CD, TV,
VIDEO 1/2, SAT/CATV
3)
1) 2)
(8 ohms 20 Hz – 20 kHz,
THD 0.09%):
100 W + 100 W
(8 ohms 1 kHz, THD 0.7%)
FRONT:
110 W + 110 W
CENTER: 110 W
SURROUND:
110 W + 110 W
SURROUND BACK:
110 W + 110 W
Measured under the following conditions:
Power requirements: 120 V AC, 60 Hz
Depending on the sound field settings and the
source, there may be no sound output.
3)
When "2ch Analog Direct" is being used.
10 Hz – 100 kHz
± 3 dB
Sensitivity: 150 mV
Impedance: 50 kohms
3)
S/N
: 105 dB (A,
20 kHz LPF. 500 mV)