Sony STR-DA2800ES Operating Instructions Manual page 124

• If the TV does not have System Audio
Control function, set the "Audio Out"
settings in the HDMI Settings menu to
– "TV+AMP" if you want to listen to the
sound from the TV speaker and
receiver.
– "AMP" if you want to listen to the
sound from the receiver. When you
connect the receiver to a video device
(projector, etc.), sound may not be
output from the receiver. In this case,
select "AMP."
• You cannot listen to the sound of a device
connected to the receiver while a TV is
selected as the input on the receiver.
– Be sure to change the input of the
receiver to HDMI when you want to
watch a program on a device connected
to the receiver.
– Change the TV channel when you want
to watch a TV broadcast.
– Be sure to select the correct equipment
or input you want when you watch a
program from the equipment connected
to the TV.
• When using the Control for HDMI
function, you cannot control the connected
equipment using TV's remote control.
– Depending on the connected equipment
and TV, you may need to set up the
HDMI setting of the equipment and TV.
Refer to the operation instructions
supplied with the equipment and TV.
– Change the input of the receiver to the
HDMI input connected to the
equipment.
Coaxial/optical input
• When "2ch Analog Direct" is being used,
the sound is not output. Use other sound
field (page 59).
• Check the INPUT MODE (page 82).
• Check to make sure the selected audio
(digital) input jack is not assigned to other
inputs in "Audio Input Assign" in the
Input Settings menu (page 83).
124
US
Analog 2 channel input
• Check to make sure the selected audio
(analog) input jack is not assigned to other
inputs in "Audio Input Assign" in the
Input Settings menu (page 83).
The left and right sounds are
unbalanced or reversed.
• Check that the speakers and equipment are
connected correctly.
• Adjust the balance parameters using the
"Speaker Setup" in the Speaker Settings
menu.
• Adjust the level of the speakers.
Dolby Digital or DTS multi-channel
sound is not reproduced.
• Check that the DVD, etc., you are playing
is recorded in Dolby Digital or DTS
format.
• When connecting the DVD player, etc., to
the digital input jacks of this receiver,
make sure the digital audio output setting
on the connected equipment.
• You can enjoy High Bitrate Audio (DTS-
HD Master Audio, Dolby TrueHD), DSD,
and multi-channel Linear PCM with an
HDMI connection only.
Multi-channel sound cannot be output.
• When "Control for HDMI" is set to "On,"
"Audio Out" may be automatically set to
"AMP." In this case, set "Audio Out" to
"AMP."
The surround effect cannot be
obtained.
• Make sure the sound field function is on
(press MOVIE/HD-D.C.S. or MUSIC).
• "PLII (Movie/Music)," "PLIIx (Movie/
Music)," "PLIIz Height," and "Neo:6
(Cinema/Music)" do not work when the
speaker pattern is set to 2/0 or 2/0.1.
Recording cannot be carried out.
• Check that the equipment is connected
correctly (page 36).
• Select the source equipment (page 49).