Table of Contents
Advertisement
Wireless remote control fl ash photography
External fl ash units that offer a remote control mode and are designated for use
with this camera can be used for wireless fl ash photography. The built-in fl ash
can independently control up to three groups of remote fl ash units. See the
documentation provided with the external fl ash units for details.
1
Set the remote fl ash units to RC mode and place them as desired.
•
Turn each fl ash unit on, press the MODE button, and select RC mode.
•
Select a channel and group for each fl ash unit.
2
Select [ON] for [# RC MODE] in X Shooting menu 2 (P. 108).
•
The super control panel switches to RC mode.
You can choose a super control panel display by repeatedly pressing the INFO
•
button.
•
Select a fl ash mode (note that red-eye reduction is not available in RC mode).
3
Adjust the settings for each group in the super control panel.
Group
•
Select the fl ash control
mode and adjust the fl ash
intensity individually for
groups A, B, and C. For
MANUAL, select the fl ash
intensity.
4
Press the #UP button to raise the built-in fl ash.
•
After confi rming that the built-in and remote fl ash units have charged, take a
test shot.
Wireless fl ash control range
Position the wireless fl ash units with their
remote sensors facing the camera. The
following illustration shows the approximate
ranges at which the fl ash units can be
positioned. The actual control range varies
with local conditions.
#
Caution
•
The built-in fl ash can not be used as a light source in RC mode.
•
We recommend using a single group of up to three remote fl ash units.
•
Remote fl ash units can not be used for second curtain slow synchronization or anti-
shock exposures longer than 4 seconds.
•
If the subject is too close to the camera, the control fl ashes emitted by the built-in
fl ash may affect exposure (this effect can be reduced by reducing the output of the
built-in fl ash by, for example, using a diffuser).
Flash intensity value
A MODE
TTL
+1.0
M
1 / 8
–
OFF
CH
250
250 F5.6
0.0
0.0
Flash control
Flash
mode
intensity
Normal fl ash/Super FP fl ash
•
Switch between normal
fl ash and Super FP fl ash.
Communication light level
LO
•
Set the communication light
2
level to [HI], [MID], or [LO].
38
38
Channel
•
Set the communication
channel to the same
channel used on the fl ash.
30°
30°
30°
30°
60°
60°
50°
50°
50°
50°
100°
100°
10
EN
89
Advertisement
Table of Contents
