Replacing The Cover And Connecting The Cables - Lenovo 73879HU User Manual

6. Restart the computer, leave it on for approximately ten seconds. Turn off the
7. Repeat steps 1 through 3 on page 30.
8. Move the Clear CMOS/Recovery jumper back to the standard position (pins 1
9. Replace the computer cover and connect the power cord. See "Replacing the

Replacing the cover and connecting the cables

After working with options, you need to install any removed parts, close the
computer cover, and reconnect cables, including telephone lines and power cords.
Also, depending on the option that is installed, you might need to confirm the
updated information in the Setup Utility program.
To replace the computer cover and connect cables to your computer:
1. Ensure that all components have been reassembled correctly and that no tools
2. Reposition any cables that might impede the replacement of the computer
3. Align the drive bay assembly with the two slots and rails on the sides of the
4. Reinstall the two screws that secure the drive bay assembly.
5. Reinstall the front bezel if it was removed.
6. Position the computer cover on the chassis so that the rail guides on the sides
7. Install any locking devices such as a padlock as necessary.
8. Reconnect the external cables and power cords to the computer. See "Locating
9. To update the configuration, see Chapter 5, "Using the Setup Utility," on page
computer by holding the power switch for approximately five seconds. The
computer will turn off.
and 2).
Note: If your system board has only two pins for clearing CMOS, just remove
the jumper from the two pins.
cover and connecting the cables."
or loose screws are left inside your computer.
cover.
chassis, reconnect the drive cables on the system board, and then slide the
drive bay assembly towards the rear of the chassis until it snaps into position.
of the cover engage the rails and push the cover to the closed position. Install
the two screws that secure the computer cover.
connectors on the rear of your computer" on page 18.
41.
Chapter 3. Installing options
31