D-Link DWS-3024L User Manual page 57

Table 3. Basic Wireless Global Configuration
Field Description
WLAN Switch If the status is disabled, this field appears and one of the following reasons is
Disable Reason listed:
•
•
•
•
If routing is enabled on the switch, the operational status might be disabled
due to one of the following reasons:
•
•
For information about how to configure a loopback interface and enable
routing, see
IP Address This field shows the IP address of the WLAN interface on the switch. If
routing is disabled, the IP address is the network interface. If routing is
enabled, this is the IP address of the routing or loopback interface you
configure for the Unified Switch features.
AP Authentication Select the check box to require APs to be authenticated before they can
associate with the switch.
AP MAC Select the database to use for AP validation.
Validation
•
•
Country Code Select the country code for the country where your switch and APs operate.
A popup window asks you to confirm the change.
Wireless regulations vary from country to country. Make sure you select the
correct country code so that your WLAN system complies with the
regulations in your country. Some WLAN modes, such as the Atheros
modes, are not available in some countries.
Changing the country code disables and re-enables the switch. Any channel
and radio mode settings that are invalid for the regulatory domain are reset to
the default values.
The country code (IEEE 802.11d) is transmitted in beacons and probe
responses from the access points.
From the CLI, you can view the same information that is available on the Wireless Global
Configuration page with the
need to change the country code, you can view the list of available countries and their two-
letter codes with the
show wireless country-code
4 Installing the D-Link Unified Access System
None—The cause for the disabled status is unknown.
Administrator disabled—The Enable WLAN Switch check box has been
cleared.
No IP Address—The WLAN interface does not have an IP address.
No SSL Files—The D-Link Unified Switch communicates with the APs
it manages by using Secure Sockets Layer (SSL) connections. The first
time you power on the Unified Switch, it automatically generates a
server certificate that will be used to set up the SSL connections. The
SSL certificate and key generation can take up to an hour to complete.
No Loopback Interface—The switch does not have a loopback interface.
Global Routing Disabled—Even if the routing mode is enabled on the
WLAN switch interface, it must also be enabled globally for the
operational status to be enabled.
"D-Link Unified Switch with Routing Enabled"
Local—If you select this option, you must add the MAC address of each
AP to the local Valid AP database.
RADIUS—If you select this option, you must configure the MAC
address of each AP in an external RADIUS server.
command in Privileged EXEC mode. If you
show wireless
Enabling the WLAN Features on the Switch
command.
on page 65.
57