D-Link DWS-3024L User Manual page 54

D-Link Unified Access System User Manual
enabled in order for the switch to discover and validate D-Link Access Points. If the
routing mode is disabled, the Unified Switch function uses the IP address of the network
interface. If routing is enabled, the switch uses a loopback or routing interface for the
wireless functions. Changing the IP address of the network interface automatically
disables and re-enables the wireless function. Enabling routing also disables and re-
enables the wireless function.
4. Configure the default AP Profile settings that the access point will use after the switch
validates it.
When the switch successfully validates an access point, it sends the AP Profile to the
access point. The AP Profile contains all of the access point configuration information,
such as the radio, security, and SSID settings. You can configure all of the AP settings
before or after the switch validates an AP. For information about configuring the default
AP profile, see Chapter 5,
5. Prepare and deploy D-Link Access Points and enable AP-to-switch discovery.
After you connect an AP to the network and it obtains an IP address (either statically or
dynamically by using DHCP), the Unified Switch can automatically discover the AP.
However, if your network uses IEEE 802.1X authentication or you require the AP to be
authenticated by the switch upon discovery, you must log on to the AP and configure
security information.
6. Authenticate and validate the APs.
You can optionally configure the Unified Switch so that it only manages APs that it
authenticates. You can use the local database or an external RADIUS database for AP
authentication. Whether or not you require AP-to-Unified Switch authentication, the
switch must be able to validate an AP before it can manage the AP. For the switch to
validate the AP, you must add the MAC address of each AP to the AP database on the
switch or to the database on an external RADIUS server.
Once you validate the AP, you can use the switch to manage the AP and to view client
associations, status, and statistics.If you follow the procedures in this chapter, the APs will
have the default configuration profile. The default AP Profile settings are listed in
Appendix
CAUTION:
To prevent unauthorized access to the network by wireless clients, you can configure security
on the default profile before you deploy the APs, or you can create additional AP profiles to
assign the APs when you add them to the Valid AP database. For information about how to
configure default profile settings, see Chapter 5,
page 83.
You can use the switch to create multiple AP profiles to assign the APs that you deploy on
your network. For each profile, you can define information such as RF configuration, QoS
configuration, and virtual AP (VAP) configuration. For information about AP profiles, see
"AP Profiles, Networks, and the Local Database"
and configuring a new AP profile, see
page 155.
54 © 2001- 2008 D-Link Corporation. All Rights Reserved.
"Configuring Access Point Settings"
A.
The default AP profile does not use a security mechanism for wireless
client associations. All wireless clients will be able to connect to an AP
and access your network.
"Configuring Access Point Settings"
on page 83. For information about creating
"Creating, Configuring, and Managing AP Profiles"
on page 83.
on
on