Placement Options; Figure 4-6: Measurement Between Wall-Mount Slots - Linksys WRTP54G User Manual

Placement Options

There are two ways to place the Router. The first way is to place it horizontally on a surface, so it sits on its four
rubber feet. The second way is to mount it on a wall. This option uses the Router's four wall-mount slots on its
bottom panel. The distance between two adjacent slots is 62 mm (2.44 inches).
To use the wall-mount option, follow these instructions:
1. Make sure you have four screws that are size #4—this indicates a diameter measurement of 2.845 mm
(0.112 inches).
2. Determine where you want to mount the Router.
3. Drill four holes into the wall. Make sure adjacent holes are 62 mm (2.44 inches) apart.
4. Insert a screw into each hole, and leave 5 mm (0.2 inches) of its head exposed.
5. Maneuver the Router so the wall-mount slots line up with the four screws.
6. Place the wall-mount slots over the screws and slide the Router down until the screws fit snugly into the
wall-mount slots.
Proceed to "Chapter 5: Configuring the Router."
Chapter 4: Connecting the Router
Placement Options
Wireless-G Broadband Router with 2 Phone Ports
62 mm
(2.44 inches)
Figure 4-6: Measurement between
Wall-Mount Slots
11