Hardware Installation For Connection To Another Router; Figure 4-4: Diagram For Connection To Another Router; Figure 4-5: Connecting Another Router - Linksys WRT54GC User Manual

Compact Wireless-G Broadband Router

Hardware Installation for Connection to Another Router

Before you install the Router, you must change the default IP address of the other router. This is mandatory
because both routers may be set to the same IP address by default. If you do not change the other router's default
IP address, then you may not be able to set up the Router.
First, make sure the Router is NOT connected to your network. Then follow these instructions:
1. To access the other router's Web-based Utility, launch Internet Explorer or Netscape Navigator, and enter the
other router's default IP address, 192.168.1.1, in the Address field. Then press Enter.
2. A password request page will appear. Leave the User Name field blank. In the Password field, enter the
password you have set (the default password is admin). Then click the OK button.
3. The first screen that appears will display the Setup tab. In the Network Setup section, there is a setting called
Local IP Address (also called Router IP), which is set to 192.168.1.1. Change this to 192.168.2.1.
4. Click the Save Settings button to save your change, and then exit the Web-based Utility.
5. Power down your network devices. Now you will begin the hardware installation of the Router.
6. Locate an optimum location for the Router. The best place for the Router is usually at the center of your
wireless network, with line of sight to all of your wireless devices.
7. If you are using the optional external antenna, adjust it now for optimum performance. Normally, the higher
you place the antenna, the better the performance will be.
8. Connect a standard Ethernet network cable to the Router's Internet port. Then, connect the other end of the
Ethernet cable to one of the numbered Ethernet ports on your other router.

Figure 4-5: Connecting Another Router

Chapter 4: Connecting the Compact Wireless-G Broadband Router
Hardware Installation for Connection to Another Router
NOTE: Steps 1-4 are instructions for a typical
Linksys router; however, if you are using a non-
Linksys router, refer to the other router's
documentation for instructions on how to change its
local IP address to 192.168.2.1.
Broadband
Internet
Modem
Router
Compact
Wireless-G
Broadband
Router

Figure 4-4: Diagram for Connection to Another Router

Multiple
PCs
12