Yamaha TOOLS for MY16-mLAN Installation Manual page 16

However depending on the performance of your computer and on how it is being used (i.e., whether other
applications are being used simultaneously, or whether multiple mLAN devices are connected, etc.), you
may still experience noise or sound interruption even after increasing the latency. In this case, change the
"Required CPU" setting to "Medium Performance" or "Low Performance" to lighten the processing load on
your computer, and then adjust the latency (the Preferred Buffer Size setting below) once again.
• Lower latency values result in shorter delay times and work better for real-time recording and
playback.
• Higher latency values result in longer delay times, but allow for use of more audio channels and
plug-in effects (thus reducing the computer's momentary processing load).
Conversely, if you experience no noise or interruptions even with the "Preferred Buffer Size" setting
described below set to the minimum, you can minimize the overall latency by setting Required CPU to
"High Performance" and then adjusting the latency once again.
● Latency of mLAN
Audio latency (msec)
Audio latency is determined by the "Preferred Buffer Size" setting in the "ASIO mLAN Control Panel."
The audio latency value is shown in the "ASIO mLAN Control Panel" (see below).
MIDI latency (msec)
The MIDI latency value varies with the mLAN driver version.
For information on the MIDI latency of your mLAN driver version, refer to the "MIDI_Latency.txt" file,
which you can access by selecting [Program files | mLAN Tools | YAMAHA].
● ASIO mLAN Control Panel
When you start the ASIO mLAN Control Panel, the system displays the following dialog box.
When using the mLAN ASIO Driver, open the ASIO Control Panel within the driver settings of the DAW
software (the particular menu depends on the software you are using) and set the Preferred Buffer Size
as needed.
• Also, when using the mLAN WDM driver, adjust as necessary the latency value of the WDM driver (which corre-
sponds to the latency of the ASIO driver in this chart) within the driver settings of the DAW software.
• The initial setting of the Preferred Buffer Size of the mLAN ASIO driver is the smallest value.
q Preferred Buffer Size
This parameter enables you to
specify the size of the buffer inside
the mLAN ASIO driver.
w Sample Size
This parameter enables you to
specify the bit resolution for audio
data transmission and reception.
e Latency
This field indicates the audio latency
value for transmission and reception.
Audio latency is determined by the
"Preferred Buffer Size (w)" setting.
r
OK
Click to enable the settings and close the dialog box.
t Cancel
Click to close the dialog box without changing the settings.
TOOLS for i88X/mLAN16E, TOOLS for MY16-mLAN, Plug-in Effect
16
q
w
e
r
Installation Guide
t