Cleaning The Filter Net; How To Add The Detergent; How To Add The Fabric Softener; Cleaning The Filter - Samsung SW10C1S Owner's Instructions Manual

Table of Contents

Advertisement

CLEANING THE FILTER NET

1.Push the upper part of
the filter and pull in.

HOW TO ADD THE DETERGENT

1
.
Open the detergent box
by pulling in the direction of the
arrow as shown in the figure.
2
.
Add the amount of detergent for one
washing evenly in the box so that the
detergent does not overflow the box.

HOW TO ADD THE FABRIC SOFTENER

When a proper amount of fabric softener is stored in the box,
it is automatically added in at the final rinse cycle.
In case the hot water only is connected, this function will
not be operated.
When too much softener is stored above the base line,
it may not be operated properly.

CLEANING THE FILTER

(pump drained washer)
1
.
Place a rag under washer filter not to wet the floor.
2
.
Turn the filter-cap to the left.
3
.
Take the filter out and remove dirts.
4
.
Reassemble in reverse order.

ONLY FOR THE MODEL WITH PLASTIC BASKET.

When a proper amount (one time does) of fabric
softener is stored in the softener inlet,it is
automatically put in at the last rinsing cycle.
Before operating the washing machine, make sure if
some water is remained in softener case or not. In
case of water remained, take out this case and
remove water.
5
2.Open the cover as
shown in the figure.
Fabric
softener
3.Clean the filter.
4. Close the cover and insert the lower

LEVELLING

Adjust the height control legs to make eve.
Lock
Lock Nut
UNLOCK
LOCK
Adjustable
Leg
Unlock
After slightly lifting up the machine, rotate the
adjustable leg counter-clockwise and pull
as much as need to adjust the heigh.
After putting down the machine after adjustment.
UNLOCK
LOCK
Lock
Adjust the height and secure.
Secure the lock nut by rotating it firmly.
If the lock nut is not secured, the adjustable
leg may be release.
SEE IF THE MACHINE IS PLACED LEVEL BY CHECKING THE
POSITION OF THE WASHING TUB.
Open the lid of the machine, pour water into the tub up to the level
just below the pulsator, and adjust the legs so that the pulsator
is positioned at the center of the water as shown in the figure.
Place the machine more than 10cm away from the wall.
Adjust the legs on feet for levelling .
part of the filter in the basket first and
then push the filter with "click" sound .
UNLOCK
LOCK
Unlock
Loosen
Lock

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sw10c1spWa1034d0Sw10c1p

Table of Contents