Installation & Maintenance; Environment; Connecting The Drain Hose; In Case Of Pump-Drained Washer - Samsung SW10C1S Owner's Instructions Manual

ENVIRONMENT

Leave some space
Maintain at least 10cm between the washer and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak surface,
noise or vibration occurs. (Allowable is 1°
Adjust the legs for even placement.
Never install the washer near water.
Do not place the washer in steamy rooms or where
the washer is directly exposed to rain.Moisture may
destroy the electrical insulation causing an electrical
shock hazard.
Avoid direct sunlight or heaters.
As plastic and electrical components are affected
by direct heat,never place the washer near furnaces,
boilers,etc.Do not place under direct sunlight.

HOW TO CONNECT WATER SUPPLY HOSE

A tap of ordinary type is desirable
ORDINARY TAP SQUARE TAP
1.Remove the adaptor from the
water supply hose.
2.First,using a "+" type screw
driver, loosen the four screws
on the adaptor.
Next,take the adaptor and
turn part(b) following the
arrow for gap about 5mm
between them.
3. Connect adaptor to the water
tap by tightening the screws
firmly.
Then,turn part (b) following
the arrow and put (a) and
(b)together.
INSTALLATION & MAINTENANCE

CONNECTING THE DRAIN HOSE

After pressing the joint ring(a), insert the drain hose(b)
to drain direction.
)

IN CASE OF PUMP-DRAINED WASHER

Take out the
cap-hose and
connect the
outlet-hose.
In case of square tap
° ‹Take out the internal part of the connector
and join it in the following way.
ROTATING TAP
(a)
1
(b)
Be sure to join tightly
the drain hose into the
drain-outlet on theback
of the machine.
cap-hose
outlet-hose
Internal part
4.Connect the water supply hose to
the adaptor. Pull down the part
(c) of the water supply hose .
When you release part (c) the
hose is automatically connects to
the adaptor making a 'click'
sound.
5.Connect the other end of the
water supply hose to the inlet
water valve at the top of the
washer.
Screw the hose clockwise all
the way in.
6.If the water tap is a screw
type,assemble a water
supply hose that fits to
the tap as shown.
Install the drain
hose in the position
of about 70~80cm
above the ground.
4