Presetting the Stations Manually
You do not need to preset the stations manually
if you have already set them automatically.
To enable the VCR to decode a scrambled TV
station, the decoder must be switched on.
1
Press the MENU button on the remote control.
Result: The programming menu is displayed.
2
Press the corresponding
select the INSTALLATION option.
3
Press the OK button to select this option.
Result: The INSTALLATION menu is displayed.
4
Press the corresponding
MANUAL SET UP option is selected.
INSTALL
AUTO SET UP
MANUAL SET UP
TV SYSTEM
:K
VCR OUTPUT CH :CH36
❿
END:
❷
❿
5
Press the
button to select a MANUAL SET UP
option.
Result: The TV STATION TABLE menu is
displayed.
** TV STATION TABLE **
PR
CH
NAME
1
002
CAEB
2
---
----
3
---
----
4
---
----
5
---
----
❿
SWAPPING:
❷
DELETE:
CLR/RST
6
Press the
or
buttons to select a programme
❷
number as required.
** MANUAL TUNING **
PR
:
1
CH
: ---
MFT
:
-
DECODER : OFF
NAME
: ----
➛❿
MEMORY:
❷
➛
❿
,
or
,
buttons to
❷
or
buttons, until the
❷
MENU
DEC
OFF
OFF
OFF
OFF
OFF
OK
MENU
OK
MENU
❿
7
Press the
button to preset the station.
Result: The MANUAL TUNING menu is displayed.
8
Press the corresponding
CH is selected.
➛
Press the
or
Result: The frequency band is scanned and the first
station found is displayed.
If you know the number of the channel you want,
press the numeric buttons on the remote control for
example, for channel E21, first press "0" and then
press "2", "1" (see page 33).
9
Press the
button, until the DECODER is selected.
❷
❿
10
Press the
button to activate or deactivate use of the
decoder for the TV station, if necessary.
11
Press the
or
❷
12
To change the programme's name, press the
Result: The first letter of the name flashes.
13
To...
Select a character Press the
in the name
Move to the next or Press the
previous character respectively.
14
If you...
Wish to store the
station displayed
Do not wish to
store the station
displayed
15
Repeat this procedure from Step 6 onwards, until
all the required stations have been stored.
16
On completion, press the MENU button three times
to exit the menu.
ENG-15
or
buttons, until the
❷
❿
buttons to start scanning.
buttons until the NAME is selected.
Then...
,
button until the
❷
required character is displayed
(letters, numbers or "-" character).
➛
❿
or
buttons
Then...
Press the corresponding
buttons, until the MFT is
❷
selected.
➛ or ❿
Press the
buttons to
adjust the picture, if necessary.
Press OK to store the station
Press the corresponding
buttons, until the CH is
❷
selected.
➛ , ❿
Press the
buttons to
go on scanning the
frequency band and display
the next station
Go back to the beginning of
Step 12
❿
button.
,
,