Telephone Installation - Samsung SP-C802RGL Manual

Telephone Installation

Base set Installation
●
After installation, pick up the handset and make it sure that dial tone is transmitted.
●
If there is no dial tone, check the connections of the telephone line and the power line.
●
This product should be operated at 220V only.
Remote set Installation
● Place the remote set on the charger and check whether CHARGE light turns on.
● Press button and check whether dial tone is transmitted.
●
If there is no dial tone, check whether the base set has been properly installed.
To power ON/OFF the remote set
● To power ON: Press
● If the unit is not powered on even if you press
will turn on automatically. Charge the unit for one day before using.
●
To power ON: Press and hold
8
DC 12V 500mA
DC 12V 500mA
button until the unit beeps twice.
button, place it on the charger. Later, it
button in the standby state until the unit beeps.
Placing the battery in the remote set
Open the
1
Telephone
battery lid.
Connection
Connect the
telephone to a
220V outlet.
How to use battery?
●
Charge the remote set for more than 24 hours
before initial use.
●
If you do not use the telephone for a long
time, make it sure to separate the battery
from the remote set and keep it safe.
Battery Life
Connect the
telephone to a
220V outlet.
What is the standby state?
The stadnby state refers to the state in which no call is made or answered and the unit is
ready for ringing.
(State in which the user does not speak over the phone and the telephone is waiting for
operation.)
Put the battery Put the battery Close the
2 3 4
as shown in the tight to the upper battery lid.
picture. part as shown in
the picture.
@@
@@
@@
● We guarantee the battery life of 6 months from the
purchase.
●
Battery is a consumable, whose life is reduced along with
time. If the battery performance is reduced to the half the
initial performance, purchase a new battery.
To purchase a new battery, contact Supply Division at
Samsung Electronics Service Center.
9