Anything wrong with the telephone?
There is no dial tone
The telephone does not
when I pressed
work at all.
button.
● Make it sure that the telephone is
●Make it sure that the telephone
correctly installed. (See Page 8)
line is correctly connected.
●Make it sure that the adaptor is
(See Page 8)
properly installed according to
●Make it sure that the power cord is
the specified voltage. (See Page 8)
properly connected. (See Page 8)
● Make it sure that the the battery
●Check the speaker volume.
is correctly placed in the remote
(See Page 17)
set. (See Page 9)
●Did you charge the remote set
battery enough? (See Page9)
● Is the remote set power ON?
(See Page 8)
Messages are not recorded
Station call and/or
even though the auto answering
flash does not work.
machine is turned on.
●There are too many messages
●Make it sure that the telephone is
recorded to record any more
properly installed. (See Page 8)
message.
●Register the remote set to the
base set again. (See Page 43)
●Delete the checked messages.
(See Page 21)
●Did you designate the extension
numbers when you purchased
additional remote sets to use? (See
Page 43)
46
Morning call does not
work.
●Is the current time set in the unit?
(See Page 12)
● Is the morning call time set?
(See Page 19)
● Is the morning call function
activiated? (See Page 19)
The remote set does not
ring.
●Check the battery in the remote
set. (See Page 9)
●Did you charge the remote set
battery enough? (See Page 9)
●Is the remote set power ON? (See
Page 8)
●Register the remote set to the base
set again. (See Page 43)
Cannot make a call
There is warning tone
with the additional
and I cannot make a call.
remote set.
●Is the base set/remote set in use?
●Make it sure that the remote set
(See Page10)
is properly installed.
●Did you charge the remote set
(See Page 8)
battery enough?
●Did you charge the remote set
battery enough? (See Page 9)
●Did you registered the remote set
to the base set?
(See Page 43)
●Is the remote set power ON?
(See Page 8)
The remote set is not
The remote set beeps
charged properly.
during call.
●Make it sure that the CHARGE
● Check if the base set is busy.
contact is clean.
Try to make a call after the base
set finishes its call.
●If the CHARGE contact is dirty, the
unit may not be charged properly.
●Make it sure that the remote set
Clean the CHARGE contact with
isn' t too far from the base set.
cotton swap or eraser. (See Page 48)
Move closer to the base set. (See
●Make it sure that the adaptor is
Page 11)
installed properly according to the
●
is displayed on the remote
specified voltage. (See Page 8)
set LCD and the low voltage
warning is displayed, finish the
●If the remote set is not properly
call immediately and then charge
charged even after cleaning, purchase
the remote set enough before
a new battery from the service center.
using. (See Page 41)
(See Page 9)
@@
@@ @@
Cannot talk over the
remote set due to noise
and interference.
●Press
button and you can
get clear speech quality.
(See Page 11)
●Make it sure that the remote set
isn' t too far from the base set.
(See Page 11)
● Erect the base set antenna.
● Change the base set installation
location.
47