ENGLISH
Preparing
Connecting the Power Source
There are two ways to connect power source.
-
Using the AC Power Adapter : used for indoor shooting.
-
Using the Battery Pack: used for outdoor shooting.
To use the AC Power Adapter
1. Connect the AC Power Adapter to a AC cord.
2. Connect the AC cord to a wall socket.
Note: The plug and wall socket type can be
different according to the regional
conditions.
3. Connect the other end of the DC cable to
DC jack of the camcorder.
4. To set the camcorder to CAMERA mode.
a. Hold down the tab of the power switch and
push the switch to CAMERA mode.
b. Make sure that the Lens Cap is opened.
c. Make sure that the image appears in the
Viewfinder.
Note: If the adapter is used next to the TV or the camcorder, it may
cause the TV or camcorder to emit noise. Move the adapter
away from the TV, camcorder or the antenna cable.
18
Camcorder vorbereiten
Camcorder an eine Stromquelle anschließen
Sie können den Camcorder auf zwei Arten mit Strom versorgen:
- Bei Innenaufnahmen können Sie den Camcorder über den Net-
zadapter an eine Steckdose anschließen.
- Bei Außenaufnahmen schließen Sie einen Akku an den
Camcorder an.
Camcorder an eine Steckdose anschließen
1. Verbinden Sie das Netzanschlußkabel mit dem
1
2. Schließen Sie das Netzanschlußkabel an eine
2
3. Verbinden Sie das vom Netzadapter kommende
3
4. Schalten Sie den Camcorder wie folgt in den
4-a
a. Drücken Sie auf die Zunge am Schalter für den
CAMERA
b. Stellen Sie sicher, daß die Objektivkappe
abgenommen wurde.
c. Stellen Sie sicher, daß auf dem Suchermonitor das Bild
wiedergegeben wird.
Hinweis: Wird der Adapter in unmittelbarer Nähe eines Fernsehers
oder des Camcorders eingesetzt, so können Störgeräusche
im Fernseher oder Camcorder auftreten. Vergrößern sie den
Abstand zwischen Adapter und Fernseher, Camcorder oder
Antennenkabel.
DEUTSCH
Netzadapter.
Steckdose an (Netzanschluß 100 - 240 V AC,
50/60 Hz).
Hinweis: Stecker und Steckdose können je
nach Land unterschiedlich aussehen.
DC-Kabel mit dem DC-Anschluß am Camcorder.
Aufnahme-Bereitschaftsmodus:
Betriebsmodus, und stellen Sie den Schalter auf
CAMERA.