Advertisement
The settings diagram located below is the same as the sticker that you previously installed. This diagram contains crucial
information that will allow you to select the setting that you would like your nitrous system to activate at as well as shut
down at. Depending on your engines configuration and power, the nitrous system can be programmed to activate at
between 2000 RPM and 5000 RPM and shut down between 5250 RPM and 7125 RPM. You should consult with the engine
builder and/or manufacturer to find out the rev limit for your specific engine. NEVER exceed the RPM limit of your
engine. Severe engine damage may occur!
Adjusting your control module is done very easily using a small flathead screwdriver. First, select the RPM that you would
like the nitrous system to activate at using the chart below (or the sticker supplied with the kit). Set the arrow on the left
pot to the correct number or letter for the setting you would like. Last, select the RPM
that you would like the nitrous system to de-activate and set the right pot to the correct
number or letter for the setting you would like. Below are two examples of different
settings. Once these setting have been made, your system is ready to run!
Shown above:
The left pot is at setting 7
7=3400RPM activation
The right pot is at setting A
A=6500RPM de-activation
It is the constant endeavor of Edelbrock Corporation to give our customers the highest quality products obtainable. Edelbrock
warrants each new product, except Performer Series Carburetors, Race Division Parts, Tubular Exhaust Systems, RPM Series
Mufflers, Cat-Back Systems and Performer IAS Shock Absorbers which are warranted separately, to be free from defects in both
workmanship and material for a period of one (1) year from the date of purchase, provided that the product is properly installed,
subjected to normal use and service and that the product is not modified or changed in any way, negligence by customer or
installer or used for racing or competition purposes.
Our warranty service and repair facility is located at 2700 California Street, Torrance, California 90503. Customers who believe
they have a defective product should either return it to the dealer from which it was purchased or ship it directly to Edelbrock
along with proof of purchase and a complete description of the problem. The product must be returned freight pre-paid. If a
thorough inspection of the product by the factory indicates defects in workmanship or material, our sole obligation shall be to
repair or replace the product. Warranty covers only the product itself and not the cost of installation or removal.
Edelbrock Corporation shall not be liable for any and all consequential damages occasioned by the breach of
any written or implied warranty pertaining to this sale in excess of the purchase price of the product sold.
please contact our Technical Department, toll free at 1-800-416-8628
2004 Edelbrock Corporation
Brochure #63-0131
ADJUSTING THE CONTROL MODULE
Shown above:
The left pot is at setting 2
2=2400RPM activation
The right pot is at setting 8
8=6250RPM de-activation
Edelbrock General Warranty
If you have any questions regarding a product or installation,
from 7:00 am to 5:00 pm PST,
Monday through Friday.
Examples:
Page 4 of 4
Catalog #72230
Rev. 5/04
Advertisement
