Motorola T8160 Manual page 49

Using Pause Dialing
Once stored, you may recall the entry and place the call. All of the
digits you have stored will be recalled, but your phone will only
send the tones for the set of numbers before the first pause.
1. Place Enter the two-digit memory location of the
Call Pause Dialing number and press and hold
or press
the access number and wait for your input
when it reaches the first pause.
2. Send
When the automated system prompts you
More for information, press
Numbers send the next group of numbers. Repeat this
step to send each group of numbers that you
have stored.
3. End Press
Call hold
press
Using Memory Linking
Each memory location holds up to 32 digits, including pauses.
Some automated systems, however, may require you to enter
more than 32 digits. If this is required, split the numbers into
two memory locations and recall the second set of digits as you
need them.
1. Recall 2nd Once you have sent the tones from the
Location 1st location, press
memory location where you stored the
second set of digits.
2. Send Press
Tones tones in the 2nd location. If you have stored
a pause in the 2nd location, your phone will
pause as usual when it reaches the pause
character.
æ ª
(or ). Your phone will dial
a a a a
º
, close the phone, or press &
a a a a
until you hear a high tone and
a a a a
again.
‰
and the two-digit
‰ æ ª
and (or
a a a a
æ ª
or (or ) to
) to send the
49