Table of Contents
Advertisement
Before applying power
Preparing the remote control
Insert batteries type R6/LR6 ("AA" size) into the
remote control.
Operation
When the standby indicator is lit, the power turns
ON when you press the POWER
remote control. When the power comes on, press
the button you want to operate.
Notes:
•
The supplied batteries may have shorter lives than
ordinary batteries due to use during operation
checks.
•
When the remote-controllable distance gets shorter
than before, replace both batteries with new ones.
•
Placing the remote sensor in direct sunlight, or in
direct light from a high frequency fluorescent lamp
may cause a malfunction.
In such a case, change the location of the system
installation to prevent malfunction.
CAUTION
Be sure to adhere to the following, or proper
ventilation will be blocked causing damage
or fire hazard.
• Do not place any objects impairing heat
radiation onto the top of the unit.
• Leave some space around the unit (from the
largest outside dimension including
projection) equal to or greater than, shown
below.
Top panel : 50 cm
Back panel : 10 cm
CAUTION
• Place the unit where the AC power cord can
be easily unplugged.
• The power in this unit will not be completely
cut off from the AC wall outlet when the
power switch is turned OFF . To cut off the
power completely, unplug the AC power
cord from the AC wall outlet.
4
EN
Connections
Connecting the FM antenna
Adjust the position of the FM antenna for the best
reception.
Connecting the AM antenna
button on the
Set up the AM loop antenna, and then connect it.
Speakers connection
• Connect the right speaker to terminal marked
• Connect the left speaker to terminal marked
• Clip the stripped portion of the speaker wire
Notes:
•
•
Connecting the USB cable
Connect a commercially available USB cable to
the USB port on the rear panel and connect the
other end of the USB cable to the USB port of
your personal computer.
(See "Preparations before listening to sound from
the USB terminal" on page 13.)
"R" , with the red wire to + and the black wire
to –.
"L " , with the red wire to + and the black wire
to –.
as shown.
1
2
For optimal sound performance, it is recommended
to use the supplied speakers.
Do not connect more than one speaker to any one
pair of +/– speaker terminals.
3
Advertisement
Table of Contents
