Kenwood DVF-9010 Instruction Manual page 18

To connect with an AV receiver with 6-chan-
18
nel input jacks
Connect the 6ch OUTPUT jacks of this unit with the 6ch INPUT jacks
of the AV receiver using audio cords.
In this case, make initial setup [8 Speaker Setting] according to the
speakers as shown below.
When the center speaker is not used:
\ No speaker displayed.
CENTER
When the surround speakers are not used:
\ No speaker displayed.
SURROUND
When the subwoofer is not used:
SUBWOOFER \ No speaker displayed.
To connect with an AV receiver with built-in
Dolby Digital (AC-3) decoder and digital in-
put
Connect the DIGITAL OUTPUT jack of this unit with the DIGITAL
INPUT jack of the AV receiver using an optical fiber cable or digital
cord.
NOTE: Some DVD and CD discs contain DTS data in the PCM
area. When such a disc is played, the MIX LINE OUTPUT
jack does not output correct audio.
Note on connection of optical-fiber cable
÷ Insert the optical-fiber cable straight into the connector until it clicks.
÷ Be sure to attach the protection cap when the connector is not used.
÷ Never bend or bundle the optical-fiber cable.
÷ All of the commercially-available optical fiber cables cannot be used with these units.
If there is an optical fiber cable which cannot be connected to your component, please consult
your dealer or nearest KENWOOD agent.
Copyright and copy protection notes
Manufactured under license from Dolby Laboratories.
"Dolby" and the double-D symbol are trademarks of Dolby Laborato-
ries .
Confidential Unpublished Works. c1992-1997 Dolby Laboratories.
All rights reserved.
It is prohibited by laws to duplicate, broadcast, perform in public or
rent a disc without the permission of the copyright owners.
To connect with an ordinary amplifier with 2
input channels
Set initial setup [8 Speaker Setting] as shown below.
CENTER
SURROUND
p SUBWOOFER \ No speaker displayed.
Connection of S-VIDEO jacks
The S-VIDEO connection offers clear video because it transmits the
video signal by separating it into the color (C) component and
luminance (Y) component. It is recommended to use an S-VIDEO cord
when the connected TV has an S-VIDEO input.
For details, refer to the instruction manual of your TV.
Digital output jacks (OPTICAL)
Remove the protective cap before using a
digital output jack.
This product incorporates copyright protection technology that is
protected by method claims of certain U.S. patents and other intellec-
tual property rights owned by Macrovision Corporation and other
rights owners. Use of this copyright protection technology must be
authorized by Macrovision Corporation, and is intended for home and
other limited viewing uses only unless otherwise authorized by
Macrovision Corporation. Revers engineering or disassembly is pro-
hibited.
This product is compatible with the MacroVision type copy protec-
tion. Some discs contain the recording of copy inhibit signals, and the
video may be disturbed when the video of such discs is recorded onto
a VCR and played back.
System Connections
\ No speaker displayed.
\ No speaker displayed.
Remove cap.
Optical-fiber cable
DVF-9010 (En/E)
p
OPTICAL