Table of Contents
Advertisement
I
Installing in Japanese-Made Cars
1
Refer to the section "Removing the hard rubber frame" and
then remove the hard rubber frame.
2
Align the holes in the unit (two locations on each side) with
the vehicle mounting bracket and secure the unit with the
accessory screws.
N
T
N
T/N
T
T: Toyota cars
N: Nissan cars
2CAUTION
• During installation, do not use any screws except for those
provided. The use of different screws might result in damage
to the main unit.
• Damage may occur if a screwdriver or similar tool is used with
excessive force during the installations.
I
Removing the hard rubber frame
1
8 mm
8mm
MAX.
MAX.
3
4
M5mm
M5mm
Accessory3...for Nissan car
2
Accessory4 ...for Toyota car
NOTE
The frame can be removed from the top side in the same
manner.
— 69 —
Engage the catch pins on the removal tool and remove the
two locks on the lower level.
Lower the frame and pull it forward as shown in the figure.
Accessory2 Removal tool
When the lower level is removed, remove the upper two
locations.
Catch
Lock
Advertisement
Table of Contents
