High-Pass Filter Frequency For Rear Output; Low-Pass Filter Frequency For Non-Fading Output; Phase For Non-Fading Output; Spatializer® Control Setting - Kenwood KDV-Z930 Instruction Manual

Audio effect control features
<When the KDS-P901 is not connected>

2.High-pass Filter Frequency for Rear Output

Adjust the frequency of the High-pass filter for rear output.
Display and setting:
"REAR HPF" : THROUGH / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz
/ 150Hz / 180Hz / 220Hz
NOTE
You can separately set the high-pass filter for front and rear
output, including preouts. The high-pass filter does not affect the
non-fading preout.

3.Low-pass Filter Frequency for Non-Fading Output

Adjust the frequency of the Low-pass filter for Non-Fading
output.
Display and setting:
"NF LPF" : 50 Hz / 80 Hz / 120 Hz / THROUGH
NOTE
This mode is available only when the non-fading output function
is set to on.

4.Phase for Non-Fading Output

Adjust the phase for Non-Fading output.
Display and setting:
"NF Phase" : Normal (0°) / Reverse (180°)
NOTE
This mode is available only when the non-fading output function
is set to on.
Spatializer® Function Setting:
You get a 3-D stereo effect when the Spatializer® function is
turned ON.
1
Hold down the 3-D button for one second or more to enter the
3-D stereo control mode.
The Spatializer® function is turned on.
2
Selecting mode
Each time you press the 3-D button to switch the Spatializer®
function as follows:
" BYPASS " / " LOW " / " MID " / " HIGH "
3
Press the 3-D button for one second or more to end the 3-D
stereo control mode.
NOTE
If you make no button operation for 10 seconds, the 3-D stereo
control mode is automatically canceled.
Turning the Spatializer® function Off:
1
Select the "BYPASS" mode.
2
Press the 3-D button for one second or more.
— 22 —