Connecting Wires To Terminals - Kenwood KDC-PS907 Instruction Manual

Connecting Wires to Terminals

UNBALANCED BALANCED
Left -
Left
FRONT
Right -
Right
Left Left +
REAR
Right +
Right
Left Monaural +
NON-FADING
Right Monaural -
Non-fading right/ Balanced monaural
If no connections are made, do not
let the wire come out from the tab.
When using the optional power amplifier,
connect to its power control terminal.
Ground to any metal part of the
car through the switch.
Ignition key
switch
Car fuse box
(Main fuse)
+ –
Battery
Rear left/ Balanced left
Front right/
Balanced right output (Red)
-
Front left/
Balanced left - output (White)
output (Red)
-
Non-fading left/ Balanced monaural
FM/AM antenna input
P.CONT.OUT
VALET
ACC
Car fuse box
output (White)
+ Rear right/ Balanced right
NON-FADING
+ output (White)
Fuse
Power control wire (Blue/White)
Valet wire (Pink)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
output (Red)
+
REAR
FRONT
KENWOOD disc
changer control input
NOTE
To connect the Disc
changer, consult your
Disc changer manual.
Wiring harness
(Accessory1)
2WARNING
If you connect the ignition wire
(red) and the battery wire (yellow)
to the car chassis (ground), you
may cause a short circuit, that in
turn may start a fire. Always
connect those wires to the
power source running through
the fuse box.
33