Connecting Wires To Terminals - Kenwood KDC-1020 Instruction Manual

Connecting Wires to Terminals

If no connections are made, do not let the wire come out from the tab.
5 When using the optional power amplifier,
connect to its power control terminal.
7 Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for
the booster amplifier of the film-type antenna.
Ignition key
switch
10
Car fuse box
(Main fuse)
11
–
+
Battery 12
Front left output (White) (KDC-4020 only)
Front right output (Red) (KDC-4020 only)
2 KENWOOD disc changer control input (KDC-4020/3020/2020 only)
To connect the Disc changer, consult your
Disc changer manual. 3
Fuse (10A)
Power control wire (Blue/White)
P.CONT
ANT.
Motor antenna control wire (Blue)
CONT.
17
ACC 13
Car fuse
box 14
Ground wire (Black) · (To car chassis)
26
27
24
4
Wiring harness
(Accessory1)25
15
Ignition wire (Red) 20
Battery wire (Yellow) 21
22
— 16 — — 16 —
Rear left output (White)
Rear right output (Red)
REAR
L
FM/AM antenna input
R
29
White/Black
To front left
speaker 30
FRONT • L
White
31
32
Gray/Black
To front right
speaker 33
FRONT • R
Gray
34
35
Green/Black
To rear left
speaker 36
REAR • L
Green
37
38
Purple/Black
To rear right
speaker 39
REAR • R
Purple
40
23
28
1