Connecting Wires To Terminals - Kenwood DPX-MP2100 Instruction Manual

Connecting Wires to Terminals

⁄
To connect the Disc changer, consult your
Disc changer manual.
To Kenwood disc
changer/ External
optional accessory
Fuse (10A)
Power control wire (Blue/White)
Motor antenna control wire (Blue)
TEL mute wire (Brown)
Dimmer control wire (Orange / White)
External amplifier control wire (Pink / Black)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
|
24
English
FM/AM
antenna input
Wiring harness
(Accessory1)
If no connections are made, do not let the wire come out from the tab.
White/Black
White
FRONT L
Gray/Black
Gray
FRONT R
Green/Black
Green
REAR L
Purple/Black
Purple
REAR R
Front left output (White)
Front right output (Red)
Rear left output (White)/ Sub Woofer left output (White)
Rear right output (Red)/ Sub Woofer right output (Red)
When using the optional power amplifier, connect
to its power control terminal.
P.CONT
Depending on what antenna you are using, connect
either to the control terminal of the motor antenna, or
to the power terminal for the booster amplifier of the
ANT. CONT
film-type antenna.
Connect to the terminal that is grounded when either
the telephone rings or during conversation.
MUTE
⁄
To car light control switch.
ILLUMI
To "EXT.AMP.CONT. " terminal of the amplifier having the
external amp control function.
EXT.CONT.
To front left
speaker
To front right
speaker
To rear left
speaker
To rear right
speaker
Car fuse box
ACC
To connect the Kenwood navigation system,
consult your navigation manual.
Ignition key
switch
Car fuse box
(Main fuse)
–
+
Battery