Table of Contents
Advertisement
General features
X'Over & Amp Control
1
Enter Audio Control mode
Press the [AUD/X'Over] button for at least 1 second.
"AUDIO CONTROL MODE" is displayed.
2
Select the X'Over or Amp Control mode
Press the [AUD/X'Over] button.
Select the "X'OVER CONTROL" (X'Over Control mode) or "AMP
CONTROL" (Amp Control mode) display.
Each time the button is pressed the Audio control, the X'Over
control and the Amp control switch.
3
Select the X'Over & Amp Control item for adjustment
Press the [FM] or [AM] button.
Each time the button is pressed the items that can be adjusted
switch as shown below.
4
Adjust the Audio item
Press the [4] or [¢] button.
5
Exit Audio Control mode
Press the [AUD/X'Over] button for at least 1 second.
X'Over control mode
Adjustment Item
Display
Front High Pass Filter
"HPF-Front"
Rear High Pass Filter
"HPF-Rear"
Low Pass Filter
"LPF"
*
Non-Fading level
"N-F Level"
*
Non-Fading Phase
"N-F Phase"
*
Range
Off/ 40/ 60/ 80/ 100/ 120/
150/ 180/ 220 (Hz)
Off/ 40/ 60/ 80/ 100/ 120/
150/ 180/ 220 (Hz)
50/ 80/ 120/ Off (Hz)
- - - — +10
Normal (0°)/Reverse (180°)
— 16 —
Amp control mode:
Adjustment Item
Display
Bass boost level
"Amp Bass"
Central frequency boost "Amp Freq"
• * This mode is available only when <Switching preout> (page 30)
is set on "N-F".
• Refer to the catalog or instruction manual for power amplifiers that
can be controlled from this unit.
• For amplifiers there are the model that can be set from Flat to +18
dB, and the model that can be set from Flat to +12 dB.
When an amplifier that can only be set to +12 is connected to the
unit, "Amp Bass +18" won't work correctly even if it's selected.
X'Over Preset Memory
You can store into or recall from memory up to three X'Over
settings.
1
Adjust the X'Over to put in the memory
Refer to <X'Over & Amp Control> (page 16).
2
Put the X'Over setting in the memory
Press the [#1] — [#3] button for at least 2 seconds.
The preset number display blinks 1 time.
3
Exit Audio Control mode
Press the [AUD/X'Over] button for at least 1 second.
Recalling the X'Over setting
1
Enter X'Over Control mode
Refer to <X'Over & Amp Control> (page 16).
2
Call up the X'Over setting
Press the [#1] — [#3] button.
3
Exit Audio Control mode
Press the [AUD/X'Over] button for at least 1 second.
Range
Flat/+6/ +12/ +18 (dB)
Normal/ Low
Advertisement
Table of Contents
