Selecting A Source; Selecting The Computer Or Video Source - NEC NP-UM330X User Manual

 Selecting a Source

Selecting the computer or video source

NOTE: Turn on the computer or video source equipment connected to the projector.
Detecting the Signal Automatically
Press the SOURCE button once.The projector will search for the available
input source and display it. The input source will change as follows:
COMPUTER → HDMI1 → HDMI2 → VIDEO → S-VIDEO → VIEWER →
USB DISPLAY → COMPUTER → ...
• With the SOURCE screen displayed, you can press the SOURCE
button a few times to select the input source.
TIP: If no input signal is present, the input will be skipped.
Using the Remote Control
Press any one of the COMPUTER 1, HDMI, VIDEO, S-VIDEO, VIEWER,
NETWORK, or USB DISPLAY buttons.
NOTE: The HDMI button on the remote control will toggle between "HDMI1" and
"HDMI2". Upon the first button push the projector will always switch to HDMI 1 IN. A
second button push will then switch to HDMI 2 IN. if there is only one HDMI source
connected to the projector it is recommended to place that signal on the HDMI 1 IN
connector.
Selecting Default Source
You can set a source as the default source so that it will be displayed
each time the projector is turned on.
1. Press the MENU button.
The menu will be displayed.
2. Press the  button twice to select [SETUP] and press the  but-
ton or the ENTER button to select [GENERAL].
3. Press the  button four times to select [OPTIONS(2)].
4. Press the  button five times to select [DEFAULT SOURCE SE-
LECT] and press the ENTER button.
The [DEFAULT SOURCE SELECT] screen will be displayed.
(→ page 95)
5. Select a source as the default source, and press the ENTER button.
6. Press the EXIT button a few times to close the menu.
7. Restart the projector.
The source you selected in step 5 will be projected.
NOTE: Even when [AUTO] is turned on, the [NETWORK] will not be automatically
selected. To set your network as the default source, select [NETWORK].
TIP:
• When the projector is in Standby mode, applying a computer signal from a
computer connected to the COMPUTER IN input will power on the projector
and simultaneously project the computer's image.
([AUTO POWER ON(COMP.)] → page 95)
• On Windows 7, a combination of the Windows and P keys allows you to set up
external display easily and quickly.
2. Projecting an Image (Basic Operation)
18